faq
  • 2018-04
    The installation of the buried scraper conveyor requires the following work: 1) Positioning of the buried scraper conveyor: first, fix the position of the head and the tail, then confirm the center line of the scraper conveyor.
  • 2018-04
    4.Scraper conveyor body 1, scraper, chain (1) Scraper bending deformation shall not be greater than 5mm. The wear length of the double-chain and medium-chain scraper shall not exceed 10mm. (2) The elongation of the ring chain must not exceed 2% of the design length. Chain ring diameter wear should not exceed 1-2mm.
  • 2018-04
    1.Scraper conveyor head ,tail drive 1)There is no welding in the nose, tail, transition slot and bridge. 2)The head stock, tail stock,and transition slot must be tightly connected. Up and down left and right stagger no more than 3mm. 3)The pressure chain device is firmly connected and the wear should not exceed 6mm.
  • 2018-04
    The cement screw conveyor is widely used in the cement silo discharge point, because its space is small, the conveying angle and rotation angle are easy to be adjusted, so it greatly reduced the time cost. However, the screw conveyor has strict requirements in operation in order to enable cement screw conveyors have a long service life, please remember the following items when transporting materials:
  • 2018-04
    Cement machine for inspection.All the same time,always check and clean up the machine shell and other parts of the accumulation or entanglement.Before commissioning the tube screw conveyor, it should first confirm that the machinery and equipment are in good condition, the fasteners and running parts are normal, the connection pipeline is firm and reliable, and the necessary lubrication of the rotating parts is required.
  • 2018-04
    Cement spiral conveyors can be used in industries such as mixing plants, lime plants, cement plants, chemical plants, steel mills, etc. It is the most suitable equipment for conveying powdered materials, granular materials, and small blocks, such as cement, fly ash, fertilizers, mineral powder, sand, soda ash, ash, pulverized coal, etc
  • 2018-04
    The bucket chain bucket and shell collision noise. When the chain bucket hoist is used for a long time, the chain will pull to a certain extent, which will cause the chain to loose. When the hoist is swaying around the chain during the operation, the hopper will collide with the chassis easily. The solution is to adjust the tightening device to make the chain sloshing around 3 millimeters.
  • 2018-04
    Most of the materials that are lifted by vertical bucket elevator are dry powder or small lump particles. Therefore, material spilled or dust will inevitably appear, which will easily cause noise of bucket elevator operation. Today we are going to analyze the cause of the noise in the bucket elevator.
  • 2018-03
    Vertical bucket elevator can be widely used in several industries such as mining, mineral, chemical, agriculture, power, food and other industries etc.
  • 2018-03
    The failures of the TH-type ring chain bucket elevator are mostly due to the unreasonable design position of the bottom bearing, poor maintenance and adjustment of the tensioning device, unclear repair quality standards, unclear wear quality of the chain and sprocket wheel slot, and uneven feeding,the lincomprehension of each parts function, poor control of the moisture content of the material and other reasons.
 837   Home Previous 6 7 8 9 10 11 12 13 14 15 16 17 Next Last